Communication Technology DPM105 paging mic

DPM105 5 zone paging microphone

Communication Technology DPM105 is a multi-zone self-cancelling paging point (microphone console) which is operated exclusively with the ZRU010 (sold separately) relay interface and central logic processor, accessing up to 5 zones. Systems can be cascaded to increase the zoning capacity.

Picture shows the DPM105 and DPM100 zone paging systems for illustration only (series includes five zone, ten zone paging, ZRU010 zone switcher, EXT122 system expander and ZRU-PSU24V power supply for the ZRU010.

Please note a Planning and Installation Manual is available, in advance of product purchase, to aid in system design.

DPM Series Multi-zone Paging Systems

Whilst most system designers will switch zones of loudspeakers, this system is sufficiently versatile to also operate between pre-amplifiers, 600 Ohms signal sources or with individual zone amplifiers.

Each paging point (microphone console) incorporates a line pre-amplifier and in-built pre-announcement 'gong'. Zone commands from paging point to ZRU010 are simply expressed as a change of DC level; no microprocessors are included, no skilled programming is therefore necessary.

Operation of the Press-To-Talk button activates the zone relays; after release, (on completion of the page) zone relays are automatically de-energised and the system is returned to its normal state. Importantly the operator does not have to remember to cancel the selected zone(s).

Up to four paging points (microphone consoles) can be connected to the system. In systems with more than one paging point, if the system is occupied, the Press-To-Talk LED will continuously flash to indicate the system is in use. (Upgrade to accommodate up to 8 paging points: EXT122).

Zone pre-selection is still possible whilst queuing for system access and once the system is released any other microphone can enter the system with their pre-selected zone choice.

Provision is made to connect a dedicated music amplifier and a separate paging amplifier. When a system is configured this way, paging into individual zones will not disturb the distribution of music to others. Full music and/or paging 'lock out' options are provided on all zones. The zone switching relays may also be used to route music and paging commands to separate zone amplifier inputs, operating at line level.

Features of the DPM105/DPM110

Fully automatic All-Call
Pre-selection of zones prior to paging, self cancelling after use
Whilst waiting for paging access to the system, users can pre-select their zones to be paged
One paging point can be designated to have overall priority in the system
Up to four paging points can comprise a multi-zone system
System access can be made through host amplifier input 'gates', priority 24V operation of loudspeaer zone relays, or to individual zone or to individual zone amplifiers, fed at 600 Ohm line level,
0dBm, allowing use of low cost 'ungated' amplifiers

Models in series

ZRU 010: 1U rack mounting relay/zone processor
DPM105: Self-cancelling 5 zone paging point
DPM110: Self-cancelling 10 zone paging point
EXT 122: Input extender for ZRU 010; one input expanded to two point, so that up to eight DPM105/110 can be utilised in a system
DPM102: Single zone, pre-amplifier
DPM202: Two zone, pre-amplifier
PAN406: Pre-announcment 'gong'
ZRU 010: 1U rack mounting relay/zone processor
DPM105: Self-cancelling 5 zone paging point
DPM110: Self-cancelling 10 zone paging point
EXT 122: Input extender for ZRU 010; one input expanded to two point,
so that up to eight DPM105/110 can be utilised in a system

PRE600: Microphone pre-amplifier board only, 600 Ohms (may not be used as retrofit)
PRE600/P: As PRE600 but built into wall or desk mounting secure housing

Specification DPM105 - 5 zone

Press- To-Talk/All-Call Momentary action button
Zone Selection Momentary action, electronic locking buttons with individualconformation LEDs
Paging Point Output OdBm, 600 Ohms, balanced, with pre-announcment gong provision
Zone Relay Load Will accept the output of a 250W amplifier, line voltage up to 100V or 600 Ohms line level switching
Power Requirement 24V to 30V D.C 150m
Cabling Requirements 25 way 'D' interface to the ZRU010 relay interface and central processor
Dimensions
DPM105 - 130(W) x 168(H) x 50(D) mm
ZRU 010 - 483(W) x 170(H) x 43.25(D) mm
Weight 950g
Finish:
Microphone Body Black powder coat
Microphone Top Brushed stainless steel
Microphone and Gooseneck Matt black

FREE AV Guide - Click to download

Tel 01754 898900 | Fax 01754 898910 | Email